1 Liddell St, North Shields, NE30 1HE
Sentinel Marine Guard is a laid-up vessel monitoring system that alerts owners and marina and harbour staff to flooding, listing or movement of the vessel when there is no crew on board.
Thousands of vessels sit idle in UK and international ports, many with fuel and oil on board. Owners of these out of service vessels spend tens of thousands of pounds a year on regular inspections. But between visits, nobody is watching.
Sentinel Marine Guard gives you early warning. Water level sensors in the hull and bilge detect water ingress and instantly alert owners and marina staff. The affected position on the vessel is highlighted by the app and action can be taken straight away. Geofencing allows the exact position of the vessel to be monitored, if there is any unauthorised movement a notification appears on the app, alerting the owner.
Sentinel Marine Guard provides continuous flood and list monitoring for vessels of up to 250m, with alerts for unauthorised movement, whilst they are unattended in port.
Sentinel Marine Guard brings together proven Succorfish hardware and software to give vessel owners and marina managers peace of mind for laid-up, out of service or abandoned vessels. This remote vessel monitoring system combines highly reliable connectivity and location tracking with beacon and flood detection technology. As soon as water or any unauthorised movement are detected, a push notification is triggered via the Sentinel Marine Guard App, so action can be taken straight away.
The intelligent edge communications gateway for the system, the SC2 Gateway receives sensor events from the GIGO beacons over Bluetooth Low Energy (BLE) and transmits them to the Succorfish Data Platform over Cat 1 Bis LTE or satellite. The SC2 Gateway also works as a marine GPS tracker: precise location data allows the vessel’s berth to be geofenced, with alerts for any unauthorised movement.
The Succorfish GIGO beacons are mounted on deck, relaying water detected events from the water level sensors to the SC2 Gateway. They use low power Bluetooth 5.0, with a range of 30 to 100m in open conditions, and each beacon runs for approximately 3 years on a single lithium battery. Up to 8 beacons can be installed across hull and bilge to suit each vessel.
Sentinel water level sensors are installed along the hull and at the lowest accessible point in the bilge, each wired to a GIGO beacon. Up to 8 water sensors are installed on the vessel and together they act as a bilge alarm system across the entire vessel, each triggering within 30 seconds of water contact to raise a flood alert in the Sentinel Marine Guard App.
The Sentinel Marine Guard App shows your vessel and monitoring system status. Each water level sensor can be seen at its installed position on the vessel, historic alerts and current status are easy to view and notifications in the event of water ingress arrive almost instantly.
The Sentinel Marine Guard App gives owners and marina staff a live view of every monitored vessel. It is remote bilge monitoring, in your pocket, giving a live view of every sensor across the hull and bilge. Screens for beacon status, active alerts, alert history and system health checks make monitoring your unattended vessels simple. Once installed, the system sends an automatic status report to your mobile app twice a day, and any alerts about your vessel come through as soon as they happen.
Sentinel Marine Guard is installed by Succorfish or an approved partner. The SC2 Gateway is mounted at the highest point of the vessel for the strongest LTE and satellite connection, while water level sensors and GIGO beacons are fitted across the vessel, with multiple beacons placed in hull and bilge positions. Each beacon is commissioned to its exact position using the Succorfish Installer Application, so every alert shows precisely where water has been detected. The system is flexible and can be configured for vessels of any size up to 250m, with additional sensors available as part of a custom installation.
Sentinel Marine Guard can be configured with additional sensor types to suit the laid-up vessel and its monitoring requirements, including:
With a custom configuration, the system alerts on fire and security events, such as unauthorised boarding, as well as flooding and listing. Contact the Succorfish team to discuss your requirements.
Idle and abandoned vessels often still carry fuel, lubricating oil, hydraulic fluid and contaminated bilge water. If water ingress goes undetected, a vessel can sink at its berth and release these into the harbour. The owner then faces clean-up, salvage and wreck removal costs. If the vessel is abandoned, those costs can fall on the port or marina.
Common causes of slow water ingress on unattended vessels include ageing hull fittings, failed stern glands, blocked drains and heavy rainfall. With water ingress detection at the onset, Sentinel Marine Guard gives operators time to intervene before a vessel sinks or a pollution incident occurs.
Sentinel Marine Guard provides remote vessel monitoring for any vessel left unattended, from leisure boats in a marina to commercial vessels of up to 250m in port.
Vessels taken out of service for a seasonal lay-up, a refit, or while awaiting sale or charter are often moored for months with no crew on board. Between scheduled inspections, Sentinel monitors the hull and bilge for water ingress and sends flood and list alerts to owners and marina staff, along with alerts for any unauthorised movement. Operators can reduce routine visits and attend when an alert requires it.
Vessels left without an owner or maintenance deteriorate over time, which raises the risk of sinking and pollution. When an abandoned vessel sinks at its berth, the clean-up, salvage and wreck removal costs can fall on the port or marina. Sentinel gives port authorities and harbour masters early warning of water ingress before it becomes a salvage operation.
Vessels detained under court order must be kept safely afloat throughout legal proceedings, and the arresting party or custodian can be responsible for the vessel’s condition while it remains in port. Sentinel monitors arrested vessels for flooding, listing and unauthorised movement.
Hulks awaiting disposal, recycling or removal are typically in poor condition and left unattended for long periods, so slow water ingress is more likely and less likely to be noticed. Sentinel water level sensors detect water at the onset, giving time to pump out or arrange removal before the hulk sinks at its berth.
Barges, pontoons and transport vessels are often held in port between offshore oil and gas and wind farm projects. Sentinel monitors these assets continuously while they are out of use, so operators can be confident they remain afloat and secure until the next project begins.
Our team are here to help

